# Neue Publikationen in Ziel-Venues – 2026-11-01 Neue Werke: 5 · davon mit DE-Affiliation: 5 Venues: 60 · abgefragt ab publication_date 2026-10-02 · letzter Lauf: 2026-11-01T18:00:50 ## Optics Express (OE) — 3 neu · _photonics_ ### Compact low-frequency optomechanical triaxial inertial sensor ⚑ DE - **DOI:** [10.1364/oe.612634](https://doi.org/10.1364/oe.612634) - **Metadaten:** Erschienen: 2026-10-08 · Vol. 34, Issue 21, S. 40501 · OpenAlex seit 2026-08-22 - **DE-Institutionen:** Leibniz University Hannover; Max Planck Institute for Gravitational Physics - **Autoren:** - Daniel George — University of Arizona (US) - Jose D. H. Rivero — University of Arizona (US) - Moritz Mehmet — Leibniz University Hannover (DE); University of Arizona (US); Max Planck Institute for Gravitational Physics (DE) - R Miranda Espino — University of Arizona (US) - Xiangyu Guo — University of Arizona (US); Arizona State University (US) - Andrea Nelson — Lawrence Livermore National Laboratory (US); University of Arizona (US) - Jose Sanjuán — University of Arizona (US) - Felipe Guzmán — University of Arizona (US) - **Topics:** Mechanical and Optical Resonators; Geophysics and Sensor Technology; Pulsars and Gravitational Waves Research - **Keywords:** optomechanical accelerometer; satellite geodesy - **Abstract:** Triaxial optomechanical accelerometers offer a compact, ground-testable complement to free-fall electrostatic accelerometers used in satellite geodesy, alongside applications in seismometry and precision metrology. We demonstrate a compact triaxial inertial sensor using monolithic fused-silica resonators with dual heterodyne interferometric readout. The X axis reaches a 0.3 pm/Hz readout noise floor, measured with the test mass mechanically anchored, which translates to 60 pico-g/ Hz in acceleration at 1 Hz, and the in-plane axes resolve ambient seismic ground motion in agreement with a commercial seismometer mounted on the same platform, from 4 mHz to 7 Hz. The Z axis exhibits higher noise under 1 g loading due to gravity-induced geometric stiffening (44.45 Hz versus 11.07 Hz in a horizontal configuration equivalent to 0g), with its readout noise floor, rescaled to the 0g-equivalent resonance, projecting substantially improved in-orbit performance, though short of parity with the in-plane axes. The in-plane results support optomechanical accelerometry for ground-based seismometry, while full triaxial operation for compact, secondary spacecraft accelerometry will require further Z-axis resonator development. ### Phase and amplitude pre-shaping for a high-power ps-wedged thin-disk amplifier ⚑ DE - **DOI:** [10.1364/oe.613864](https://doi.org/10.1364/oe.613864) - **Metadaten:** Erschienen: 2026-10-08 · Vol. 34, Issue 21, S. 40240 · OpenAlex seit 2026-10-09 - **DE-Institutionen:** Deutsches Zentrum für Luft- und Raumfahrt e. V. (DLR) - **Autoren:** - Pirmin Schweizer — Deutsches Zentrum für Luft- und Raumfahrt e. V. (DLR) (DE) - Raoul‐Amadeus Lorbeer — Deutsches Zentrum für Luft- und Raumfahrt e. V. (DLR) (DE) - Jochen Speiser — Deutsches Zentrum für Luft- und Raumfahrt e. V. (DLR) (DE) - T. Dekorsy — Deutsches Zentrum für Luft- und Raumfahrt e. V. (DLR) (DE) - **Topics:** Solid State Laser Technologies; Laser-Matter Interactions and Applications; Photonic Crystal and Fiber Optics - **Keywords:** femtosecond pulses; thin-disk amplifier; high-power lasers; pulse shaping; chirped pulses - **Abstract:** Wedged thin-disk amplifiers offer a compact, monolithic alternative to conventional thin-disk multipass systems. As a trade-off, the wedged shape inherently introduces complex thermal lensing and phase distortions, degrading beam quality at high output powers. We demonstrate a spatial light modulator based adaptive phase and amplitude correction system for pre-compensation of aberrations. Utilizing the large acceptance angle of the wedged thin-disk, the adaptive element can be introduced before the optical amplification. Starting with M 2 ≃ 1.2 at 25 W, we obtain near diffraction limited beam quality M 2 = 1.3 for 150 W of output power, estimate a good beam quality (M 2 < 2) for up to 250 W, and reach up to 330 W of average power. This demonstrates the readiness of the technology for modern industrial and scientific applications. ### Pipelined spiking neural network equalizer architecture designed for CMOS implementation in IM/DD optical transmission systems ⚑ DE - **DOI:** [10.1364/oe.611451](https://doi.org/10.1364/oe.611451) - **Metadaten:** Erschienen: 2026-10-08 · Vol. 34, Issue 21, S. 40435 · OpenAlex seit 2026-10-09 - **DE-Institutionen:** Huawei German Research Center - **Autoren:** - Shuangxu Li — Huawei German Research Center (DE) - Vincent Scholl — Huawei Heisenberg Research Center (Munich) - Georg Böcherer — Huawei Heisenberg Research Center (Munich) - Stefano Calabrò — Huawei German Research Center (DE) - **Topics:** Optical Network Technologies; Neural Networks and Reservoir Computing; Semiconductor Lasers and Optical Devices - **Keywords:** spiking neural networks; neural network equalizer; pipelined architecture; CMOS implementation; intensity modulation and direct detection; optical communication systems; optical neural networks - **Abstract:** High-capacity optical communication systems require nonlinear equalization with high throughput and low activity in intensity-modulation/direct-detection (IM/DD) receivers. We propose a pipelined leaky integrate, discharge, and firing (LIDF) spiking neural network (SNN) architecture designed for future CMOS implementation. LIDF separates integration from discharge and firing into two stages and combines reversed receptive field encoding with end-of-time membrane decoding. The behavioral model builds on a previously reported non-leaky two-phase circuit evaluated through SPICE simulations in the SkyWater 130 nm PDK. The synaptic-current and membrane-leakage dynamics introduced here are evaluated behaviorally on the PyTorch/Norse platform. In simulated IM/DD links, LIDF achieves gains of approximately 0.2 dB over a reference SNN equalizer, 0.7 dB over a nonlinear artificial neural network equalizer, and 1.7 dB over a linear equalizer at a pre-FEC bit-error rate of 2 · 10 −3 . The regularized configuration exhibits up to 91% lower spike activity under simulated conditions, indicating the potential to reduce spike-dependent dynamic energy in an event-driven implementation. ## Optics Letters (OL) — 1 neu · _photonics_ ### Generation of elliptically polarized high harmonics by an ω + 4 ω bicircular laser field ⚑ DE - **DOI:** [10.1364/ol.610975](https://doi.org/10.1364/ol.610975) - **Metadaten:** Erschienen: 2026-10-08 · Vol. 51, Issue 21, S. 6018 · OpenAlex seit 2026-10-09 - **DE-Institutionen:** Max-Born-Institute for Nonlinear Optics and Short Pulse Spectroscopy - **Autoren:** - Nikolai Zhavoronkov — Max-Born-Institute for Nonlinear Optics and Short Pulse Spectroscopy (DE) - Ulrich Bengs — Max-Born-Institute for Nonlinear Optics and Short Pulse Spectroscopy (DE) - Dejan Milosevic — University of Sarajevo (BA); Academy of Sciences and Arts of Bosnia and Herzegovina (BA); Max-Born-Institute for Nonlinear Optics and Short Pulse Spectroscopy (DE) - **Topics:** Laser-Matter Interactions and Applications; Terahertz technology and applications; Orbital Angular Momentum in Optics - **Keywords:** high harmonic generation; elliptical polarization - **Abstract:** We present a combined experimental and theoretical study of high-harmonic generation driven by an ω +4 ω two-color bicircular laser field. By exploiting the circularly polarized components of the driving field, we generate extreme-ultraviolet radiation consisting predominantly of harmonics with the same helicity, resulting in a strongly chiral harmonic spectrum. Individual harmonics exhibit ellipticities of up to 0.8, demonstrating the feasibility of generating elliptically polarized attosecond pulse trains. We further show that varying the ellipticity of the 4 ω driving field provides an effective means of controlling both the spectral distribution of the emitted radiation and the polarization state of the generated harmonics. Theoretical simulations are in good agreement with the experimental results, providing insight into the harmonic-generation mechanism and elucidating the role of contributions from the magnetic quantum numbers m =±1. ## Advanced Optical Materials (AOM) — 1 neu · _materials_ ### Strong Enhancement of Er 3+ Emission at Room Temperature in Si 3 N 4 Metasurfaces ⚑ DE - **DOI:** [10.1002/adom.71998](https://doi.org/10.1002/adom.71998) - **Metadaten:** Erschienen: 2026-10-30 · OpenAlex seit 2026-11-01 - **DE-Institutionen:** Friedrich Schiller University Jena - **Autoren:** - Fengkai Wei — Friedrich Schiller University Jena (DE) - Xinru Ji — École Polytechnique Fédérale de Lausanne (CH) - Tobias Jan Kippenberg — École Polytechnique Fédérale de Lausanne (CH) - Duk‐Yong Choi — Australian National University (AU) - Carsten Ronning — Friedrich Schiller University Jena (DE) - **Topics:** Metamaterials and Metasurfaces Applications; Photonic and Optical Devices; Luminescence Properties of Advanced Materials - **Abstract:** ABSTRACT We report room‐temperature photoluminescence (PL) enhancement at from ion‐implanted Er 3+ ions in Mie‐resonant silicon nitride metasurfaces. Following annealing at , nanocylinders with a radius of exhibit an 18.1‐fold detected PL enhancement relative to a planar film. The measured lifetime decreases from to , corresponding to approximately 9.4‐fold shortening. These observations and electromagnetic simulations are consistent with modified spontaneous‐emission dynamics, although excitation, non‐radiative relaxation, and collection also influence the detected intensity. Annealing increases PL and narrows the radius‐dependent enhancement peak: Gaussian fits give geometric full widths at half maximum of approximately before annealing and after annealing. These widths describe the PL enhancement peak; linking them to the optical resonance requires an independent linewidth measurement. Across implantation energies of , depth and total implanted dose vary together, so the increased PL tracks the larger implanted Er population. This CMOS‐compatible platform combines enhanced telecom‐band Er emission with scalable fabrication and room‐temperature operation, offering potential for compact, integrated light sources.